Drives
For this method, we still need to power on the drive with the "half open tray"
If using a 360 to power the drive this method can be tricky to accomplish.
You need to power on the drive with Eject status closed but Tray Half Open - To do this using an Xbox 360 as Power source, eject the DVD drive, then, press eject to 'close' the tray. Now this is the important part - you MUST remove the DVD power plug from the DVD Drive BEFORE it closes fully.
Wait for a few seconds and replace the power plug into the DVD drive taking extreme caution to plug the plug the right way around - once done, the drive is now powered, console thinks its closed but it is in fact half open.
Using a Connectivity Kit / Xtractor to power the drive
The easiest way to do this is to use manual eject before powering the drive, to manual eject simply push this slider along until Tray is released
Then, pull the tray out fully and push half way back in. Now, hook it up to the PC using
Connectivity Kit and Sata and power on. Page 5 of 72
Now, with the eject status set, Open Jungleflasher, you will be presented with the Welcome
Screen
- After a few seconds the main window will load.
- Now, click the DVDKey32 Tab
Select Correct I/O port (check for drive propeties in Drive Properties section) it should report as PLDS DG-16D2S (unless spoofed), you can choose to dump dummy.bin only as opposed to all
4 files (Key, Inquiry, Identify and dummy.bin)
- Then, simply click Dummy from iXtreme
Save as prompted, and proceed from Page 12
Save as prompted, and proceed from Page 12
Post a comment